Welcome to EgoCap2

EgoCap2 is a multi-sensor recording device that synchronously saves four video streams, audio, and motion sensor data. This help center is intended for device users and does not require development or command-line experience.

Recommended reading order

For your first use, follow these steps in order:

1. Before you begin
2. 5-minute quick start
3. Start and stop recording
4. Confirm a successful recording

:::tip Current version This page applies to EgoCap2 firmware 0.5. You can use the version menu at the top of the page to switch to documentation for other firmware versions. :::

Keep in mind

• Before recording, make sure an SD card is installed and has enough free space.
• A rapidly flashing blue light means the device is still preparing; it does not mean that valid data is already being saved.
• After stopping a recording, wait for the device to finish finalizing before disconnecting power or removing the SD card.
• Do not disconnect power, remove the SD card, or press buttons repeatedly during a firmware update.

If the device behaves differently from this documentation, first see Indicator lights and Common issues.